I have been trying to deploy Solid Edge V19 for approximately 6 months in our organization. Due to personnel changes, the method of deployment, and the high number of seats needing to be deployed, I'm still waiting. I have now made the decision to go straight to V20 given it's stability and timing of release. The new person in charge of application deployment has figured out how to deploy Solid Edge through our deployment system, so aside from some volume testing, we are just waiting on released code (I'm still testing V20). Now I'm going to be on the hook for training our users on 2 versions instead of 1. I better get started on pulling together some documentation :)
If you are not familiar with the Solid Edge Replace Part command, it is an Assembly based command used to do what the name implies… replace a part or sub-assembly with another part or sub-assembly. In past releases of Solid Edge, the Replace Part command was a solo act that had the ability of replacing a single part or sub-assembly occurrence or all occurrences of that selection with a user specified replacement part or sub-assembly that already existed. With the release of Solid Edge ST5 and subsequent releases, the Replace Part command was actually expanded into 4 different Replace Part commands, each with their own specific capabilities. Replace Part Replace Part is similar to the previous Replace Part command in that it is used to replace a part with one that has already been created, however it was expanded to allow not only the selection of a single occurrence or all occurrences of the selection, but also allows a user to select different parts and/or specified num...
Comments