Skip to main content

Dimension Projection Line Breaks

Often when placing dimensions on drawings, the projection lines of some dimensions will cross the projection lines of other dimensions as shown below.

Solid Edge provides a function to automatically create breaks in one extension line where it crosses another. This function is called "Add Projection Line Break". It is accessible from the Shortcut Menu when you have a dimension highlighted.




The result is shown below.


If you wish to remove the projection line break, highlight the dimension, invoke the shortcut menu, and select "Remove Projection Line Break".

Labels

Labels:

Comments

Tushar Suradkar said…
The context menu no doubt stores a treasure trove of options but designers are in such a hurry to finish off the work at hand.

I'd suggest making the context menu options available on the Command Bar as well which will definitely help unearth them and find greater use.
November 9, 2015 at 5:13 PM
Post a Comment

Popular posts from this blog

Solid Edge Replace Part Options

If you are not familiar with the Solid Edge Replace Part command, it is an Assembly based command used to do what the name implies… replace a part or sub-assembly with another part or sub-assembly. In past releases of Solid Edge, the Replace Part command was a solo act that had the ability of replacing a single part or sub-assembly occurrence or all occurrences of that selection with a user specified replacement part or sub-assembly that already existed. With the release of Solid Edge ST5 and subsequent releases, the Replace Part command was actually expanded into 4 different Replace Part commands, each with their own specific capabilities. Replace Part Replace Part is similar to the previous Replace Part command in that it is used to replace a part with one that has already been created, however it was expanded to allow not only the selection of a single occurrence or all occurrences of the selection, but also allows a user to select different parts and/or specified num...
Post a Comment
Read more

Solid Edge ST7

Solid Edge ST7 is not due for release until July 2014, but it appears it is actively being worked on by SE Development as witnessed by a recent post from Dan Staples on the GTAC Solid Edge discussion group where he revealed a new enhancement by accident.  Whoops!  No worries, it was a simply a setting switch so he really didn't let much of the cat out of the bag (tip of a whisker?). The good news is that we have several more months till launch so he has plenty of time to reveal more about ST7, and knowing Dan, he might let a few teasers out just to keep things interesting. BETA should commence in early spring, and the official launch will occur at Solid Edge University 2014 in May.  No doubt Synchronous Technology based modeling will continue to be a focus, but it's anyone guess as to what the other areas of focus are...
Post a Comment
Read more

The Early Bird Gets the Worm…

Solid Edge University 2013’s ( http://www.solidedgeu.com/ ) first Early Bird Discount is about to expire on 3/29/2013.  If you are planning on going, this is your chance to save $100.  Details:  http://www.solidedgeu.com/registration-fees-and-travel If you are having trouble convincing someone that the benefits of attending SEU far outweigh the costs, check out the following page: http://www.solidedgeu.com/benefits-of-attending The main event that covers Solid Edge is complemented by a pre-event that covers customization using Solid Edge’s programming API and two post-events covering FEMAP and the SharePoint based data management solutions: http://www.solidedgeu.com/event-details A partial list of events have been posted that give a taste of some of the sessions that will be available, but this isn’t all so please check back for more later: http://www.solidedgeu.com/courses If you would have something to share and would like FREE admission to the conference, think abo...
Post a Comment
Read more